IPhone 7 and iPhone 7 Plus: hold down the Side button and Volume Down button until the device reboots. IPhone 6s and earlier, iPads: hold the Home button and the Lock button until the device reboots. To leave the recovery mode, perform the following steps. For example, the above screen shot demonstrates bootloader version iBoot-6723.42.4, which was used in iOS 14.2 through 14.2.1. If this is the case, Elcomsoft iOS Forensic Toolkit will display the range of iOS versions based on the detected bootloader version. Note that some versions of iOS are based on the same bootloader version. How can one determine the version of iOS based on the bootloader version? While Elcomsoft iOS Forensic Toolkit 6.71 and newer will display the corresponding version automatically, you can also use the table available in iBoot (Bootloader) – The iPhone Wiki. In addition, the bootloader version can be used to determine compatibility with certain unlock and extraction methods. The last use data cannot be earlier than the release date of the version of iOS installed on the device. The bootloader version is probably the most important piece, as it can be used to roughly establish the probable date the iOS device was last used. iOS version: installed iOS version number or range as estimated from the bootloader version.Īs you can see, there’s not a lot you can get from the recovery mode however, this amount of data is generally enough to request information from Apple.This information can be used to identify the version of iOS (or, of there is no concrete match, the range of iOS versions) running on the device. iBoot: this is the bootloader version in the format “iBoot-”.Note that we have not seen IMEI information on any of our test devices, with or without a SIM card. The ECID (Exclusive Chip Identification) or Unique Chip ID is an identifier unique to every unit, or more accurately, to every SoC. You can identify the model by following the link. The Recovery mode may return the following information: IOS version: installed iOS version number or range The following information is available: Device Model: iPhone8,1 When performing a forensic extraction of a device running in the recovery mode, note that only a very limited set of data will be available. Keep holding the Side button until until you see the connect to iTunes screen. Quickly press Volume up, then quickly press Volume down, then press and hold the Side (Power) button. Initial state: can be on or off, but must be connected to the computer.
Keep holding the buttons until until you see the connect to iTunes screen.Īll newer devices. Hold the Side button (power button) and Volume Down. Keep holding the Home button until until you see the connect to iTunes screen. Press and hold the Home button, then connect the device to the computer via a Lightning cable. Initial state: the device is powered down and not connected to the computer. IPhone 6s/SE and older devices equipped with a physical Home button.
0 kommentar(er)
